100% Solids Epoxy Pre-Primer is formulated for use on both steel and masonry. For rusted steel, the penetrating properties and extended dry time of this two-component epoxy seal crevices and other imperfections, promoting better adhesion for subsequent coats. For prepared masonry surfaces, V155 penetrates and seals, providing an excellent foundation for subsequent coats of Corotech epoxy floor coatings. The unique, 100% solids formula of V155 forms a sealed epoxy barrier that inhibits future corrosion. This is a two-component product that requires 3 parts of the proper "A" component mixed with 1 part of part "B" catalyst. The components are already premeasured to the proper mix ratio. No measuring required. Do not mix partial kits.
Features
Low viscosity easily fills voids and crevices
Does not shrink - eliminates craters
Chemical and fume resistant
Extended cure time allows maximum penetration
Seals previously coated concrete, masonry, and galvanized metal
Recommended For
Interior, Concrete, Galvanized Metal and Reinforced Steel. 100% Solids Epoxy Pre-Primer is designed for use on bare or previously coated concrete, “White Rusted” galvanized metal, and reinforcement of rusted steel. It seals loose edges and crevices, pinholes and other surface imperfections.
Limitations
Do not apply if material, substrate or ambient temperature is below 13°C (55°F) or greater than 32.2°C (90°F). Relative humidity should be below 90%.
Do not apply if within 5 degrees of dew point or if rain is expected within 12 hours of application.
